Aastra DT390 User's Guide download pdf (Page 16)

23/1531-ANF 901 43 C1 2013-01-04

Configuration Manual Cordless Phones DT69X/DT390

4.6.1 Phone replacement with Win-PDM, Scenario 1

3 Unsubscribe the old telephone (integrated DECT). If the unsubcribtion cannot be

performed in the phone, unsubscibe it via the IP-DECT interface. See

corresponding IP- DECT documentation.Subscribe the new phone with the

same extension number as the old phone. During the subscription procedure

WinPDM identity (User ID) will automatically be set to be the same as the

extension number.

Note: The User ID can be viewed by navigating to the menu Admin menu > Device info

> User ID.

4 Insert the new phone into a DeskPDM charger or Rack PDM charger connected

to WinPDM.

5 A pop-up dialogue appears, asking the user to decide whether to use the

Number settings in PDM or the Number settings in the device. Select PDM.

The phone will automatically be synchronized and all data and parameter

settings will be transferred to the new phone. The synchronization will take a

while if the Contacts in the original phone contains a large number of contacts.

Note: If subscribing towards an IP-DECT system, the IP-DECT software version must

be 3.1.X or higher. If not, use Scenario 2.

Note: The phone to be installed must not have any previous valid registrations.

Unsubscribe phone or use Scenario 2.

4.6.2 Phone replacement with WinPDM, Scenario 2

1 Insert the new phone into a desk PDM charger or Rack PDM charger connected

to WinPDM.

2 A pop-up will be displayed. Select the option “Associate with number”. Follow the

instructions and select the number of the old phone, see Installation and

Operation Manual, WinPDM.

The phone will automatically be synchronized and all data and parameter

settings will be transferred to the new phone. The synchronization will take a

while if the Contacts in the original phone contains a large number of contacts.

3 Subscribe the new phone.

4.7 DECT Frequency Band Configuration

Note: The frequency band configuration is only needed if other frequencies than EU

US China shall be used. Additionally, if the handset has been returned from repair, the

applicable frequency band might be set again.

In order to change the operating frequency band, the following preconditions must be

fulfilled:

• The frequency is set to “Not initiated”. This can be checked by entering the Admin

menu, see 6 Administration on page 25 follow the path: Admin menu > Device info >

Hardware. Scroll down to “Frequency band”.

• The phone must not have a DECT registration. If it already has, perform a Factory

reset, see 4.3 Perform a Factory reset on page 11.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Comments to this Manuals

No comments

Aastra DT390 User's Guide Page 16

Comments to this Manuals

Related products and manuals for Telephones Aastra DT390