Aastra DT390 User's Guide download pdf (Page 5)

23/1531-ANF 901 43 C1 2013-01-04

Configuration Manual Cordless Phones DT69X/DT390

2.1 WinPDM

WinPDM runs on a PC. The phone is configured via WinPDM as follows:

• Connect a Desk PDM charger or a Rack PDM Charger via USB to the computer

running WinPDM.

•Start WinPDM.

• Place the phone in this charger which shall be connected to WinPDM. The

telephone can either be turned off or turned on when placing it in the charger. A

telephone that is turned off will start up automatically and the battery charging

symbol will be displayed.

For instructions on how to use WinPDM, see Installation and Operation Manual,

WinPDM.

2.2 Device manager in CPDM3

The CPDM3 runs on an ELISE3 module.

• Connect a Desk PDM charger or a Rack PDM Charger via the Ethernet port to the

network.

The charger is by default configured to connect to the network using DHCP. If

DHCP is not used in the network, connect each charger via USB to WinPDM and

configure a static IP address. Enter the IP address of the CPDM3 into the PDM

charger. The PDM charger will contact CPDM3 and communicate with the CPDM

tool in the CPDM3. Please note that the USB port has priority over the Ethernet port

and has to be disconnected to be able to use the Ethernet port on the charger.

• Start the CPDM3.

• Place the handset in the charger that is connected to the CPDM3. The telephone

can either be turned off or turned on when placing it in the charger. A telephone that

is turned off will start up automatically and the battery charging symbol will be

displayed.

•

For instructions on how to use the CPDM3, see Installation and Operation Manual,

CPDM3.

3 Installation of Phones

This chapter gives an introduction on how to configure handsets using CPDM3. The

instructions in this chapter describes some basic work flows. The work flows can be

altered by, for example, using the CPDM3 wizards to a greater extent.

The chapter also describes how to add a charger in CPDM3, since a PDM charger is

required for configuring handsets using CPDM3.

For detailed information on how to work with PBX extensions, see the documentation

for each extension type. For detailed information on procedures performed from

handsets, see User Guide Aastra DT390 Cordless Phone or User Guide Aastra DT690/

DT692 Cordless Phones.

How to configure a handset depends on the type of DECT system:

• DECT (integrated DECT)

• IP DECT (SIP)

The procedures for the different types of systems are described below.

1 2 3 4 5 6 7 8 9 10 ... 41 42

Comments to this Manuals

No comments

Aastra DT390 User's Guide Page 5

Comments to this Manuals

Related products and manuals for Telephones Aastra DT390