Aastra DT390 User's Guide download pdf (Page 14)

23/1531-ANF 901 43 C1 2013-01-04

Configuration Manual Cordless Phones DT69X/DT390

• If the electrical connection is damaged, it might not be possible to follow the Easy

Replacement procedure. Depending on fault, it might work to do a replacement via

WinPDM/CPDM, see 4.5 Replacement of phone with the Device Manage (CPDM3)

on page 12 or 4.6 Replacement of the phone with WinPDM on page 13.

• If two phones and their settings shall be switched between two users, follow 4.5

Replacement of phone with the Device Manage (CPDM3) on page 12 or 4.6

Replacement of the phone with WinPDM on page 13.

4.5 Replacement of phone with the Device Manage (CPDM3)

Both the old phone and the new phone must be of the same device type (DT690,

DT692 or DT390). The same extension number is assigned to the new phone.

Make sure that the old phone is saved in the Device Manager. Start the Device

Manager in the CPDM3 and navigate to the “Numbers” tab. There shall be a tick in the

“Saved” column for the old phone.

If the phone is not saved, insert it into a desktop charger or rack charger connected to

Device Manager and perform a save, see Installation and Operation Manual, CPDM3.

If it is impossible to save the old phone settings, stop the replacement procedure.

Instead unsubscribe the old phone from the PBX, register the new phone and follow

the instructions for installing a phone.

When the phone is saved, unsubscribe the old phone from the PBX.

The following steps are described in two different scenarios, check which one suits the

best before proceeding.

4.5.1 Data included in replacement transfer

The following data is replaced during a replacement with Device Manager:

• User parameters (including User ID)

•Contacts

Note that the following data is not replaced:

• DECT registration

• Call list

• Messages

• Bluetooth pairing list

• Company phonebook

• Downloaded Language

4.5.2 Phone replacement with Device Manager (CPDM3), Scenario 1

Note: The phone to be installed must not have any previous valid registrations. If it has

a valid registration, unsubscribe the phone or use Scenario 2.

1 Unsubscribe the old telephone (integrated DECT). If the unsubcribtion cannot be

performed in the phone, unsubscibe it via the IP-DECT interface. See

corresponding IP- DECT documentation.

2 Subscribe the new phone with the same extension number as the old phone.

During the subscription procedure, the CPDM3 identity (User ID) will

automatically be set to be the same as the extension number.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Comments to this Manuals

No comments

Aastra DT390 User's Guide Page 14

Comments to this Manuals

Related products and manuals for Telephones Aastra DT390