Aastra 57i Installation Guide Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
Model 57i CT IP Phone Installation Guide 19
Installation and Setup – 57i CT Cordless Handset
Installation and Setup – 57i CT Cordless Handset
There are two steps involved in setting up the 57i CT cordless handset. The
charging cradle needs to be plugged in and the batteries need to be
installed in the handset.
Charging Cradle
The charging cradle is designed to be placed on a desk or any appropriate
flat surface. To set up the charging cradle:
1. Plug the modular cord of the power adapter into the jack on the bottom
of the cradle. Route the cord through the retaining tabs of the molded
cord slot. Verify the cradle rests on all four feet and doesn’t wobble.
2. Plug the other end of the power adapter into a non-switched AC outlet.
It is recommended that the adapter should not be plugged into an elec-
trical power bar and should be the only item plugged into the AC outlet.
Battery Installation and Charging
The handset is powered by a nickel metal hydride battery pack. To install
and charge the battery:
1. Place the battery pack in the battery compartment with the connector
wires pointing towards the bottom of the handset
2. Connect the battery terminal wire to the charging pins within the bat-
tery compartment
3. Slide the cover of the battery compartment from the bottom of the hand-
set until it locks into place
4. Place the handset, face up, in the charging cradle. The handset should
easily slide into the charging cradle. If it does not, check the battery
compartment cover to ensure it is properly closed.
5. Check the battery icon on the handset screen to confirm that it is blink-
ing and that the battery is properly charging.
The cordless handset is automatically "factory paired" to the base station
and will establish contact with the base station once both units have been
successfully installed. This connection can be verified by checking for the
presence of the Reception range icon m beside the battery icon b on the
handset screen.
Non-switched
AC Outlet
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Comments to this Manuals

No comments