Aastra 57i Installation Guide download pdf (Page 26)

20 Model 57i CT IP Phone Installation Guide

Installation and Setup – 57i CT Cordless Handset

Note: The battery must be charged for a minimum of six hours prior to initial usage

of the handset.

Belt Clip

To install the belt clip, snap one arm of the clip into the slot on the side of

the handset and then slide the other arm into the slot on the other side of

the handset until it snaps into place.

Using a Headset with your Telephone

The 57i CT cordless handset accepts headsets through the jack on the

bottom of the handset. Contact your telephone equipment retailer or

distributor to purchase a compatible headset. Customers should read and

observe all safety recommendations contained in headset operating guides

when using any headset.

Battery Status Icons

The display provides “at a glance” information on the handset battery:

Note: The handset is designed to recharge the batteries automatically, when

required and placed on the charger stand. The battery icon will not flash and

the handset does not charge every time it is placed on the stand. If a defective

battery is replaced, then the battery icon is not identified until the new battery

is charged for at least 2 minutes.

The bars indicate the bat-

tery charge level — 4 for

full, needs recharging

when only 1 bar appears.

The bars will flash when

the battery is being

recharged on the charger

stand.

Handset

(face down)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

No comments

Aastra 57i Installation Guide Page 26